Me too, both my bikes are Ultegra 10 speed and rim brakes
What Have You Fettled Today?
- Thread starter threebikesmcginty
- Start date
Page may contain affiliate links. Please see terms for details.
Me too, both my bikes are Ultegra 10 speed and rim brakes
tinywheels
Über Member
- Location
- South of hades
wacked my new wheels on ,now out on a test ride
tinywheels
Über Member
- Location
- South of hades
Ming the Merciless
There is no mercy
- Location
- Inside my skull
Fitted new bottom bracket, The old Hollowtech 2 BB had done 21,600km.
iandg
Legendary Member
- Location
- Dumfries and Galloway
Got an old child trailer in the cellar. Stripped it down to the frame. Planning making a cargo trailer to transport 2 loan bikes to bikeability sessions at primary schools.
that was brave
Windle
Über Member
- Location
- Burnthouses
I was just thinking the same thing, a scary number of complicated looking bits there and unlike in cartoon-land I don't imagine you can just throw them back at the wheel and find they've all gone back in the correct places
.
EltonFrog
Legendary Member
I was just thinking the same thing, a scary number of complicated looking bits there and unlike in cartoon-land I don't imagine you can just throw them back at the wheel and find they've all gone back in the correct places
I have all the parts, not necessarily in the right order.
All degreased and clean.
These pawl springs a fiddly little feckers.
Start to reassemble, new grease and balls.
Planetary gears and clutch.
Spring doodad and puller
Cone and lock nut in place.
Non drive side cone and bearings
Test ride all gears working perfectly. And no parts left over.
cyberknight
As long as I breathe, I attack.
- Location
- Land of confusion
Attempted to add mudgaurds to the winter bike, i have 2 sets in spares so i thought i would have something that would work....
set one was too wide for the forks so they were a non starter
set two fitted but the design of the clips that adjust the fit left much to be desired as they are plastic with a nut and bolt that goes through , i managed to snap 2 trying to tighten it up enough so it didnt rattle
I will be taking them off and snapping them into little bits and then i might stamp on the bits for good measure .
set one was too wide for the forks so they were a non starter
set two fitted but the design of the clips that adjust the fit left much to be desired as they are plastic with a nut and bolt that goes through , i managed to snap 2 trying to tighten it up enough so it didnt rattle
I will be taking them off and snapping them into little bits and then i might stamp on the bits for good measure .
bikingdad90
Guru
Are my race blades any good for you as a replacement, assuming it’s rim brake?
Chislenko
Veteran
Attempted to add mudgaurds to the winter bike, i have 2 sets in spares so i thought i would have something that would work....
set one was too wide for the forks so they were a non starter
set two fitted but the design of the clips that adjust the fit left much to be desired as they are plastic with a nut and bolt that goes through , i managed to snap 2 trying to tighten it up enough so it didnt rattle
Sounds like my garage, I appear to have amassed more spare mudguards than you can shake a stick at.
I think I blindly followed the advice "will fit up to 28mm tyre / will fit up to 38mm tyre"
Yes they may be big enough for the tyre but not for very compact caliper brakes as the caliper squeezes the mudguard down on to the tyre!!
cyberknight
As long as I breathe, I attack.
- Location
- Land of confusion
Yes I had a set years ago, I pinched the ones it had on for the commuter , how much ?
