classic33
Leg End Member
I dunno...I wrote it of course..
just like I did in secondary school wtbh was a waste of my and their time....
the white Pla I have is almost brilliant white, the PLA cleaner is a matt white.
in good light, you could see..
but it was green I changed to.....so if any blockage it more likely would be green (possible0 white as it was previously used...
Two blockages so far and both happened on change of filament, it happens.
I must change the nozzle at some point....keep it fresh.
Trying the yellow again, its sold as PLA lite..
I just noticed its on the max bed temperature for it so I'll see how it performs..
Forgot you used to write yer own for school. You got a bit of practice writing letters. Time not wasted...
I were thinking the cleaner might be coloured to show up any small bits it "found" along the way. White an obvious choice, unless you were printing in white.
Two blockages ain't too bad I suppose.
What sorta temperature is the bed?