Mundane News

Status
Not open for further replies.
Page may contain affiliate links. Please see terms for details.
PS to the above post #6786....i'm leaving the Marathon Racer, fully inflated, on the now-bust rear wheel, until the new one is unpacked and laid alongside. I can then hope that the M Racer won't have time in the 2 minutes between deflation and fitting to the new rim to shrink by the 1mm necessary to make refitting a life-changing experience. I can only hope that I can sneak up on it and it won't notice.....:ninja:
 

IDMark2

Dodgy Aerial
Location
On the Roof
Marathons....<shudder>
WP_20150704_003.jpg


:ohmy:

The Story...
 
Last edited:

EltonFrog

Legendary Member
Decided to change the cassette on my Performer recumbent. Loud crack when tightening up the lock-ring (not over-tightening it either....) and half of the side of the thread in the free-hub broke away. No matter, new free-hub for £25. But the free-hub bolt turns out not to be the std 10mm so it's a non-std Taiwanese free-hub on a Taiwanese hub and wheel (of otherwise good quality). I'll bet that a Shimano will fit - but which one? Decided to scrap the wheel and buy a new 26" Rigida rim on a Deore hub. That way I get a European std wheel for the future and I know what the components are.

What should have been a 20 min job with a new £10 12-36 cassette will now cost me £100 to get back to where I started. Is that mundane?

I think it's verging on the quite interesting.
 
Last edited:

Hill Wimp

Fair weathered,fair minded but easily persuaded.
I've just put the lamp on, it's nearly dark here, I think summer is over ^_^
Beautiful evening sunshine here.
 
Status
Not open for further replies.
Top Bottom