Rear Light for a TorTec rack

[slowmotion]

I have an Expedition rack and use Cateye lights, either a TL-LD1100 or a TL-LD600. Both these lights have a male dovetail on the back which mates with a female mounting bracket made by Cateye which screws into the two middle holes on the back-plate.

Sorry, the bracket doesn't have any serial number on it, so you will have to rummage about at the LBS.

Good luck.

 

[e-rider]

I have a similar plate on the rear of my rack. I use the light below and the additional bracket,works a dream

[url="http://www.wiggle.co.uk/p/cycle/7/Cateye_HL-LD130_and_TL-LD130_Light_Set/5360037064/"]http://www.wiggle.co...Set/5360037064/[/url]http://www.wiggle.co.uk/p/cycle/7/Cateye_HL-LD130_and_TL-LD130_Light_Set/5360037064/

http://www.wiggle.co...ing/5360032017/

I use the same bracket on my tortec rack but I use this light http://www.wiggle.co.uk/p/cycle/7/Cateye_TL-LD1100_LED_Rear_Light/5360025767/

brilliant combo

 

[Number14]

This B&M Toplight is what I have on my TorTec Expedition. It bolts directly on, no need for brackets. You may be able to get it cheaper as I personally have found SJS to be a little expensive sometimes.

There is a cheaper, non senso version available too. I would guess it has the fitting bolts as the senso version but I wouldn't swear to it.

Cheers, btw, to whoever moved this topic whilst I was in mid reply. The 'this topic does not exist' error message I got had me baffled for a moment!

I've fitted a B&M to mine. A 4D permanent which is battery operated and has 3 LEDs in the middle and one at each edge.

 

[yello]

I've fitted a B&M to mine. A 4D permanent which is battery operated and has 3 LEDs in the middle and one at each edge.

Actually, I think it's that one that I have too. It certainly looks nearer the price I paid!

 

[Sheffield_Tiger]

Same rack here, I'm now running 2 superflash lights with the rack mounting plates (1.50 each, bought from JE James on Sat despite the online price)

http://www.jejamescy...er-id17721.html

Mounted side by side by means of a couple of additional holes drilled into the rack plate

If you're only fitting one light then it bolts straight on, no drilling required

 

[piedwagtail91]

i have the b and m 4d permenant on mine. no problems with it and it's also a lot harder to nick than the clip on lights.