Which cassette spacer?

[CUBE CRD]

I've just bought a replacement Mavic Aksium one rear wheel (Shimano freehub),and to fit the 10 speed cassette I plan to use I need the 1.75 Mavic spacer (supplied with wheel) and also a 1mm Shimano one (this didn't come with the cassette).
I assume it's one of these two
http://www.wiggle.co.uk/shimano-cassette-alloy-spacer/

http://www.wiggle.co.uk/shimano-cs-hg-1mm-sprocket-spacer/

Thanks for assistance

 

[uclown2002]

The first link if you're fitting a 10 sp shimano cassette.

 

[AndyRM]

The first link if you're fitting a 10 sp shimano cassette.

Could a lack of spacer explain the play in my cassette and the fact that it sounds like a machine-gun when I go over rough surfaces?

 

[uclown2002]

Possibly but some others report no problem without the spacer!

 

[CUBE CRD]

The first link if you're fitting a 10 sp shimano cassette.

Thanks

 

[uclown2002]

Shimano 8, 9 & 10 Speed Cassette Compatibility With 11 Speed Freehub

The Dura-Ace CS-9000 & Ultegra CS-6800 HG-EV 11 Speed Cassette is 1.85mm wider than a 10 speed HG cassette, therefore the freehub dimensions have been adjusted accordingly. In order to mount a CS-9000 or CS-6800 HG-EV 11 speed cassette, an 11- speed wheel must be used.

When mounting a 10 speed cassette on the new 11 speed freehub design 2 spacers are required. Firstly a 1.85mm spacer which is supplied with the wheel, secondly a 1mm spacer which is supplied with the cassette.

To run a 8 or 9 speed cassette, only the 1.85 spacer is required.

 

[AndyRM]

Possibly but some others report no problem without the spacer!

Ta, I'll have a look over the weekend. I'm sure there's one on there but perhaps it's too narrow.