This tiny submarine 2.4 miles under the sea, visiting the relics of RMS Titanic. Can it be found and the crew saved before the air runs out?

Status
Not open for further replies.
Page may contain affiliate links. Please see terms for details.

classic33

Leg End Member
Mmmmmmmmmok... :unsure:
Is that one such site?
 
OP
OP
Accy cyclist

Accy cyclist

Legendary Member
They said the mini submarine would've taken approximately 2 hours to reach the Titanic. How long would it have taken for the Titanic itself to reach the sea bed after it went under the water, all those years ago? 🤔
 

Dogtrousers

Kilometre nibbler

Milzy

Guru
Probably longer than you might expect with the air trapped might even be similar time to the sub??

As pressure built a huge implosion would release the air tearing parts of the ship to bits. They’d have cork screwed down to the bottom in 5 to 7 minutes and hit the mud hard enough to wedge into it fairly deeply. The survivors could hear the ship buckling and exploding on its way down under the ocean.
 

Jameshow

Veteran
As pressure built a huge implosion would release the air tearing parts of the ship to bits. They’d have cork screwed down to the bottom in 5 to 7 minutes and hit the mud hard enough to wedge into it fairly deeply. The survivors could hear the ship buckling and exploding on its way down under the ocean.

But it would take time for that pressure to build as it descended... We need Reynard to umpire!🤣🤣
 
I think the main difference here is a controlled descent using ballast vs an uncontrolled descent as a result of an accident. Plus you'd get the additional effect of explosions when ice cold water hits the hot boilers* in the engine room, flashing to steam and expanding rapidly. Which would tear out bulkheads big time and increase the rate at which the ship was taking on water.

Another thing is that the compartments on the ship aren't sealed like on a sub, so the pressure equalizes with depth. It also affects buoyancy. It's something you can mess around with at home to visualise that. Fill a sink or bathtub with water, and float a small container on top - metal or glass is best. If you fill the container slowly with water, it will gradually sit lower - that's how buoyancy is controlled, ships float because of the air inside the hull. Eventually, you can fill the container till it just sinks below the water. Now do the same test, but cascade the water inside, and the container will go *flump* straight to the bottom.

* The steam in a boiler will be superheated, if I remember my thermodynamics lectures.
 
Status
Not open for further replies.
Top Bottom