Stem and aero bar torque settings

[Tin Pot]

i can't find the torque settings for Cinneli Ant stem, or Deda Parabolica aero bars...Google has not been my friend yet.

Any suggestions?

 

[Cuchilo]

It should be written on them .

 

[lpretro1]

If they are carbon usually 5-6nm tops - but check manufacturer's spec

 

[Tin Pot]

It should be written on them .

It's 6nm on the stem/steerer, but unmarked stem/bar.

The Deda have no marking as far as I can see.

 

[Tin Pot]

If they are carbon usually 5-6nm tops - but check manufacturer's spec

Yeah - where?! . Neither websites say

 

[lpretro1]

Yeah - where?! . Neither websites say

I found this without too much difficulty:-
http://www.dedaelementi.com/wp-content/uploads/2015/11/stems-handlebar.pdf

 

[Tin Pot]

I found this without too much difficulty:-
http://www.dedaelementi.com/wp-content/uploads/2015/11/stems-handlebar.pdf

Sadly this doesn't contain information for Deda Parabolica.

 

[lpretro1]

Sadly this doesn't contain information for Deda Parabolica.

Well your product is a DEDA ELEMENTI product and it says
"DEDA ELEMENTI and MUD components are designed to operate properly
within a tightening range of 4 to 5 N•m" - so that's what I'd go with personally