Banjo
Fuelled with Jelly Babies
- Location
- South Wales
Can anyone tell me where the drop or reach is measured .I am guessing its center of the fixing bolt to center of the brake pads?
Last edited:
Reach or Drop Measurement on caliper brakes?
- Thread starter Banjo
- Start date
Page may contain affiliate links. Please see terms for details.
RecordAceFromNew
Swinging Member
- Location
- West London
Your guess is spot on.
Doyleyburger
Veteran
- Location
- NCE West Wales
Good job I searched this as I was just about to post the same question.
OP
OP
Banjo
Fuelled with Jelly Babies
- Location
- South Wales
Thanks for that I was toying with the idea of replacing my front Canti on the tourer with a caliper as it screaches a lot, Cleaned the pads and set toe in (yet again) which has helped a bit so lost interest in the project for now. It has a 80mm drop which limits what you can fit on there and knowing my luck would still screach .
