Crown race tool

[midlife]

Screw on the top race past the cut then unscrew it back over the cut threads..

 

[rogerzilla]

A seat tube from an old steel frame works, provided you have a tube cutting guide to saw it straight. You use the butted end (BB end) which is usually about 26.6mm ID.

 

[midlife]

For that small amount I’d be tempted to use a spacer or two

 

[Teamfixed]

True, but had none and quite confident that this new hs is easy to replace being a common height

 

[Gixxerman]

The same multi-purpose length of threaded bar and various washers I use for BBs, spacing rear triangles and hanging rolls of tape on when not in use

I have one of those too, for pulling in steering head bearing cups. Plus a length of 22mm copper pipe with 4 cuts in one end and the cut ends splayed out, and a large bolt covered with tape to make it a snug fit in pipe with washers attached stuffed up t'other end. Used with a mallet for extracting steering head bearing cups. Plus a length of poly waste pipe for seating crown races.