endura overshoes issue

[hero of valour]

hi guys, I got some and they seem ok, but their rubbing the side of my crank arm and im worried it'll wear a hole in them...anyone got any tips for this? i cant adjust my feet or crack arms as their set in a way to reduce knee pain....any tips much appreciated....im sure ai read something about someone putting some sort of patch on them where ir rubs...

 

[fossyant]

Your only choice might be to put a patch on them if you can't adjust the shoe/cleats.

 

[HLaB]

I would be interested to here responses because I'm similar, adjusted my cleats so as to eradicate knee pain but indoing so my ankle rubs. Its more evidend wit SPDs than SPD-SL's; so I've been using the latter more of late.

 

[User6179]

I used Power tape , one bit lasted the whole of last winter (3000 miles)

 

[Gez73]

My Endura MT 500 overshoes rub the crankarm too but only for a very small time and then it stops. I assume because the rubber on the front of the overshoe is being worn with each stroke. Checked the overshoes and there is a flat/worn area on the point of contact but the rubber is quite thick so a hole is very unlikely. Not too worried about it to be honest. A very hard-wearing overshoe and highly recommended by me.

 

[400bhp]

Endura overshoes are w_ank

That's all you need to know.