Selling this as now surplus to requirements. I've put the hybrid back to manual and now use a different bike for the commute.
Condition is used but good. Purchased new September 2023 and has done approximately 300 miles commuting.
Full rear hub motor kit including motor wheel, battery, battery holder, charger, controller, LCD screen, PAS sensor, 2 types of magnet disc and all wires and connectors. Also includes aftermarket torque arm
MXUS XF08C motor (36V 250W, 45nm torque) laced into a 700c x 16mm wheel rim, with freehub for cassette bikes. Suitable for rim or disc brakes (6 bolt attachment)
King Meter KM529-LCD handlebar mounting display with 5 assist levels
36V 460Wh battery pack (Samsung cells), locking with 2 keys.
Downtube battery holder and bolts for bottle cage attachment
Lishui 36V motor controller board built into battery holder
PAS sensor (seatpost mount type)
Solid magnet disc for square taper BB spindles
Split magnet disc for other BB types and chainsets where there's insufficient space for the solid disc (attaches to chainring)
All cables and connectors (no throttle supplied, pedal assist cadence sensor operation only)
Cost new was £534, looking for £200 collected from Morley, Leeds. Cannot post whole kit due to rules around lithium ion batteries but may post other components by arrangement with buyer.
As installed on my bike -bike not included!
Condition is used but good. Purchased new September 2023 and has done approximately 300 miles commuting.
Full rear hub motor kit including motor wheel, battery, battery holder, charger, controller, LCD screen, PAS sensor, 2 types of magnet disc and all wires and connectors. Also includes aftermarket torque arm
MXUS XF08C motor (36V 250W, 45nm torque) laced into a 700c x 16mm wheel rim, with freehub for cassette bikes. Suitable for rim or disc brakes (6 bolt attachment)
King Meter KM529-LCD handlebar mounting display with 5 assist levels
36V 460Wh battery pack (Samsung cells), locking with 2 keys.
Downtube battery holder and bolts for bottle cage attachment
Lishui 36V motor controller board built into battery holder
PAS sensor (seatpost mount type)
Solid magnet disc for square taper BB spindles
Split magnet disc for other BB types and chainsets where there's insufficient space for the solid disc (attaches to chainring)
All cables and connectors (no throttle supplied, pedal assist cadence sensor operation only)
Cost new was £534, looking for £200 collected from Morley, Leeds. Cannot post whole kit due to rules around lithium ion batteries but may post other components by arrangement with buyer.
As installed on my bike -bike not included!
Last edited:
