mikkamakka
New Member
- Location
- Budapest Hungary
Hello Forum!
I have recently bought a Cannondale Supersix EVO HM frame and I wish to put on my Shimano Ultegra crankset using some of the 'conversion tools' in the market e.g. from Praxis or BBInfinite to prevent creakings.
But having some confusion to decide the the exact converter since my BB30 has no BB shell 'going through' but only the bearing rings holding the bearing. And these bearing rings seem to be glued into the carb frame(see the pic) My question is: do I need to remove these rings (somehow) and put a BB30 shell before converting it to Shimano pressfit 24 or... any of the below companies or other ones having a solution already that fit into these rings installed?
(I hope I managed to decribe my problem properly since my english is not that perceft..
)
I have recently bought a Cannondale Supersix EVO HM frame and I wish to put on my Shimano Ultegra crankset using some of the 'conversion tools' in the market e.g. from Praxis or BBInfinite to prevent creakings.
But having some confusion to decide the the exact converter since my BB30 has no BB shell 'going through' but only the bearing rings holding the bearing. And these bearing rings seem to be glued into the carb frame(see the pic) My question is: do I need to remove these rings (somehow) and put a BB30 shell before converting it to Shimano pressfit 24 or... any of the below companies or other ones having a solution already that fit into these rings installed?
(I hope I managed to decribe my problem properly since my english is not that perceft..
)
